contact us
0085258080076
sales@switech-hk.net
603E, 6/F, Hang Pont Commercial Building, 31 Tonkin Street, Cheung Sha Wan, Kowloon, HongKong
Operation Guide

How to trigger out the Hot Spot in the E-Map when the Alarm In occurs

This article is edited by HongKong Switech Co. Limited,which is the provider of Hikvision CCTV and Dahua CCTV.You can contact with our saler and technicist for more Hikvision and Dahua Production and Service in http://www.switech-hk.net/.


Step 1 at first, you should add the map which you need in the Map interface. You can click the icon just like a pen, and then click the right mouse in the dark area in the Map interface.blob.png

Step 2 and then you can open the folder where the map was located

blob.pngStep 3 and then you can click the right mouse to add the hot spot in your map

Step 4 and then you can select one of the channels which you need.

blob.png

What’s more, you can preview the channel video when you click the hot spot in the Map interface. As follows:

blob.png

Step 5. You should click the right mouse at the device when you enter into the ‘setup’ interface. And then it will pop up the ‘Remote setting’ and you can choose the ‘Alarm Input Setting’ and select the ‘Alarm Status’ type which should be matched with your alarm type, and then set the Alarm Handle and the Arm Schedule.

blob.png

Now let’s zoom in the interface as follows:

blob.png

Step 6. You should choose the weekday and the period you need, and you’d better copy the whole week.

blob.png

Step 7 . You should choose the ‘Upload to Center’ when you enter into the ‘Alarm Trigger Mode’.

blob.png

Step 8 and then you should choose the Trigger out channel which you need in the Trigger Recording interface.

blob.png

Step 9 and now, you should click the device before you choose the ‘E-Map Alarm’ in the Alarm Link interface.

blob.pngStep 10 and then you should alarm software when you preview the device.

blob.png

Step 11 and now the hot spot will blink when you setup successfully.

blob.png






TOP